DCW 120 MF Controller | Food & Beverage | Chemical dispensing & decanting
Single channel controller, freely programmable for the following potentiostatic sensors: pH, redox (ORP), conductivity, temperature, turbidity, oxygen, nitrate. For amperometric sensors: Cl2, COl2, O3, H2O2, PES, bromine, each for a mA or a mV signal input.

Inputs
– Input 1: for measurement cells 4 to 20 mA at 12/24 V, galvanically isolated
– Input 2: for measurement cells ±0 to 2000 mV
– Input 3: Flow meter (inductive proximity switch, PNP)
– Input 4: Control input NO/NC with adjustable delay
– Input 5: for stand-by
Outputs:
– Output 1: 4 to 20 mA, transmission of measured or set point
– Output 2: 4 to 20 mA, transmission of measured or set point
– Output 3: relay output for dosing pumps (230 V AC, pulse or cycle)
– Output 4: relay output (control, P, PI, or PID)
– Output 5: relay output for alarm
Controller 1: PID behaviour
Option: RS 485 serial port, Modbus protocol
Integrated safety features, e.g. in case of mains failure or lack of water
Dosing rate can be monitored; in case of excessive dosing at full
Rate an alarm is triggered. Two limits can be set.
Data/parameters are saved even in case of power failure
DCW120 controller provides inputs for conductivity or inductive probes

Wide range of pH probes are available for use with DCW 120 controller to suit any specific application

Peristaltic pumps, Solenoid diaphragm pumps and AODD pumps are available for use with DCW120 controller for dosing chemicals

Take a look at our range of products